Dual Bridge Clevis Pins provide two independent strain gage circuits. Dual Bridge transducers may use both bridges for simultaneous control and measurement or use a single bridge for measurement with the other bridge reserved as a spare.

Electrical terminations can be radial or axial using either single or dual connectors (dual shown below). Permanently attached cables can also be provided
Unit of Measure

Specifications

Bridge Composition

N/A Full

Bridge Excitation

N/A 10 (typical), 12 maximum Vdc

Bridge Resistance

N/A 350 (nominal) Ohm

Bridge Sensitivity

N/A 0.5 and higher mV/V

Temperature, Zero Load

N/A 0.01% (nominal) ±F.S./°F

Temperature, F.S. Load

N/A 0.01% (nominal) load/°F

Zero Balance

N/A 3.0% (nominal) ±F.S.

Non-Repeatability

N/A 0.25% (nominal) ±F.S.

Non-Linearity

N/A 1 % (nominal) ±F.S.

Hysteresis

N/A 1 % (nominal) ±F.S.

Safe Overload

N/A 150% (typical) ±F.S.

Ultimate Strength

N/A 300% (typical) ±F.S.

Minimum Pin Diameter

N/A 1 (standard), 0.5 (with limitations) inch

Material

N/A 17-4 Stainless Steel (typical)

Dual Bridge Wiring Diagram

N/A
dual-bridge-wiring-diagram