| Items |
 CPA-0.375-1 Load Pins |
CPA-0.5-1 Load Pins |
CPA-0.75-1 Load Pins |
CPA-1 Load Pins |
CPA-1.25 Load Pins |
|||||
| Overload without Zero Shift | 150% | |||||||||
| Overload without Failure | 300% (Minimum) | |||||||||
| Bridge | Full bridge 350 Ohm (Nominal) | |||||||||
| Excitation | 12 V AC (Maximum) 12 V DC (Maximum) | |||||||||
| Output Signal1 | 2-mV/V (Nominal) 2-mV/V (Standardized Output) | |||||||||
| Non-Repeatability | ±0.15% FS (Nominal) | |||||||||
| Non-Linearity | ±0.50% FS (Nominal) | |||||||||
| Hysteresis | ±0.50% FS (Nominal) | |||||||||
| Service Temp Range | to 150 °F | |||||||||
| Temp Effects (on Zero) | 0.005% FS / °F (Nominal) | |||||||||
| Temp Effects (on Output) | 0.008% load / °F (Nominal) | |||||||||
| Zero Balance2 | ±2% FS (Nominal) | |||||||||
| Load Capacity | 1,500 lb | 3,000 lb | 6,000 lb | 12,500 lb | 18,000 lb | |||||
| Material | Stainless Steel 17-4, H-1025 (Standard) | |||||||||
| A - Width of Center Loading Section | 3/8 in | 1/2 in | 11/16 in | 11/16 in | 1 in | |||||
| B - Width of Clevis Support Section | 5/16 in | 3/8 in | 7/16 in | 15/32 in | 5/8 in | |||||
| C - Length of Pin/Bolt Reduced Section, Instrumented Zone | 3/16 in | 1/4 in | 5/16 in | 5/16 in | 3/8 in | |||||
| Dp - Nominal Pin Diameter | 0.375 in | 0.499 in | 0.750 in | 0.999 in | 1.249 in | |||||
| E - Active Length of Pin | 1-3/8 in | 1-3/4 in | 2-3/16 in | 2-1/4 in | 3 in | |||||
| F - Clevis Pin Head Length | 2 in | |||||||||
| H - Width of Keeper Plate Slot | 13/64 in | 13/64 in | 13/64 in | 13/64 in | 17/64 in | |||||
| J - Depth of Keeper Plate Slot | 1/4 in | |||||||||
| Lp - Overall Length of Pin | 3-11/16 in | 4 in | 4-1/2 in | 4-3/4 in | 5-5/8 in | |||||
| LB - Overall Length of Bolt | ||||||||||
| W - Allowance for Retaining Ring Installation | 5/16 in | 1/4 in | 5/16 in | 1/2 in | 5/8 in | |||||
| X - Thread Length | ||||||||||
| Z - Thread Size | ||||||||||
| Keeper Plates | SPA-12.5-112-1-A | SPA-12.5-112-1-A | SPA-12.5-112-1-A | SPA-12.5-112-1-A | SPA-16-112-1-A | |||||
| Connector Type | Axial Connector Permanently Attached Axial Cable | |||||||||
| Receptacle | PTIH-10-6P | |||||||||
| Mating Plug | PT06A-10-6S (SR) | |||||||||
| Function | Pin | |||||||||
| (+) Excitation | A | |||||||||
| (-) Excitation | D | |||||||||
| (+) Signal | B | |||||||||
| (-) Signal | C | |||||||||
| Cable | #20(26x34) AWG., rubber insulation, shielded, rubber jacket, 4-Conductor (Standard Cable) | |||||||||
| Function | Wire Code | |||||||||
| (+) Excitation | Red | |||||||||
| (-) Excitation | Black | |||||||||
| (+) Signal | Green | |||||||||
| (-) Signal | White | |||||||||
|
||||||||||
