Features
|
|
Specifications
Shackle Size |
N/A 1-1/4 Inch |
Load Capacity |
N/A 25000 lb |
Material |
N/A Stainless Steel 17-4, H-1025 (Standard) |
Dp - Nominal Shackle Bolt Diameter |
N/A 1.375 in |
AE - Shackle Opening |
N/A 2.03 in |
AE - Tolerance ± |
N/A 0.13 in |
BC - Width of Shackle Ear/D (Nominal) |
N/A 1.38 in |
C - Clevis Bolt Head Diameter |
N/A 2.000 in |
H - Inside Length of Chain Shackle |
N/A 4.25 in |
H - Inside Length of Anchor Shackle |
N/A 4.68 in |
R - Outside Diameter of Shackle Ear (Nominal) |
N/A 2.87 in |
T - Thread Size |
N/A 1-14 UNF |
Shackle Type |
N/A Anchor Shackle Chain Shackle |
Connector Type |
N/A Permanently Attached Cable |
Performance Specs
Overload without Zero Shift |
N/A 150% |
Overload without Failure |
N/A 300% (Minimum) |
Bridge |
N/A Full bridge 350 Ohm (Nominal) |
Excitation |
N/A 12 V AC (Maximum) 12 V DC (Maximum) |
| Output Signal1 | N/A 2-mV/V (Nominal) 2-mV/V (Standardized Output) |
Non-Repeatability |
N/A ±0.15% FS (Nominal) |
Non-Linearity |
N/A ±0.50% FS (Nominal) |
Hysteresis |
N/A ±0.50% FS (Nominal) |
Service Temp Range |
N/A to 150 °F |
Temp Effects (on Zero) |
N/A 0.005% FS / °F (Nominal) |
Temp Effects (on Output) |
N/A 0.008% load / °F (Nominal) |
| Zero Balance2 | N/A ±2% FS (Nominal) |
- 1 Exact output provided with calibration data. (Standardized outputs are optional). In addition, Strainsert factory calibrations are intended to simulate installed conditions, however, it is recommended that an in-place calibration be performed to account for any installation, tolerance, and/or alignment influences affecting sensor measurement.
- 2 Prior to loading, it is necessary to initially/periodically null the zero load output to account for any residual offset.
