Features
|
|
Specifications
Load Capacity |
N/A 16,000 lb |
Wire Rope Diameter |
N/A 0.56–0.63 Inch |
Material |
N/A Stainless Steel 17-4, H-1025 (Standard) |
A - Width of Center Loading Section |
N/A 13/16 in |
B - Width of Clevis Support Section |
N/A 17/32 in |
C - Length of Pin Reduced Section, Instrumented Zone |
N/A 3/8 in |
Dp - Nominal Pin Diameter |
N/A 1.187 in |
E - Active Length of Pin |
N/A 2-5/8 in |
F - Clevis Pin Head Length |
N/A 2 in |
G - Extension of Pin for Keeper Plate Installation |
N/A 5/8 in |
H - Width of Keeper Plate Slot |
N/A 17/64 in |
J - Depth of Keeper Plate Slot |
N/A 1/4 in |
L - Overall Length of Pin |
N/A 5-1/4 in |
U - Nominal Spacer Thickness |
N/A 1/8 in |
Weight |
N/A 2.1 lb |
Safety Factor |
N/A 4.1 |
Keeper Plates |
N/A SPA-16-112-1-A |
Connector Type |
N/A Axial Connector Permanently Attached Axial Cable |
Performance Specs
Overload without Zero Shift |
N/A 150% |
Overload without Failure |
N/A 300% (Minimum) |
Bridge |
N/A Full bridge 350 Ohm (Nominal) |
Excitation |
N/A 12 V AC (Maximum) 12 V DC (Maximum) |
| Output Signal1 | N/A 2-mV/V (Nominal) 2-mV/V (Standardized Output) |
Non-Repeatability |
N/A ±0.15% FS (Nominal) |
Non-Linearity |
N/A ±0.50% FS (Nominal) |
Hysteresis |
N/A ±0.50% FS (Nominal) |
Service Temp Range |
N/A to 150 °F |
Temp Effects (on Zero) |
N/A 0.005% FS / °F (Nominal) |
Temp Effects (on Output) |
N/A 0.008% load / °F (Nominal) |
| Zero Balance2 | N/A ±2% FS (Nominal) |
Electrical Specifications
Receptacle |
N/A PTIH-10-6P |
Mating Plug |
N/A PT06A-10-6S (SR) |
Function |
N/A Pin |
(+) Excitation |
N/A A |
(-) Excitation |
N/A D |
(+) Signal |
N/A B |
(-) Signal |
N/A C |
Cable |
N/A #20(26x34) AWG., rubber insulation, shielded, rubber jacket, 4-Conductor (Standard Cable) |
Function |
N/A Wire Code |
(+) Excitation |
N/A Red |
(-) Excitation |
N/A Black |
(+) Signal |
N/A Green |
(-) Signal |
N/A White |
- 1 Exact output provided with calibration data. (Standardized outputs are optional). In addition, Strainsert factory calibrations are intended to simulate installed conditions, however, it is recommended that an in-place calibration be performed to account for any installation, tolerance, and/or alignment influences affecting sensor measurement.
- 2 Prior to loading, it is necessary to initially/periodically null the zero load output to account for any residual offset.
