Strainsert, Inc.
Strainsert, Inc.
12 Union Hill Rd.,
West Conshohocken, PA 19428
Phone: 610-825-3310 • Fax: 610-825-1734
Email: info@strainsert.com • Website: www.strainsert.com
Print Back
Unit of Measure

Features

N/A

  • Precison Load Sensing
  • Rugged
  • Internally Sealed Strain Gages
  • Easy Installation
  • Direct Force Measurement
  • High Strength Stainless Steel

Dimensional Drawing

Dimensional Drawing

 N/A
SPA Clevis Pin
 SPAdim.jpg

Specifications

Load Capacity

 N/A 16,000 lb

Wire Rope Diameter

 N/A 0.56–0.63 Inch

Material

 N/A Stainless Steel 17-4, H-1025 (Standard)

A - Width of Center Loading Section

 N/A 13/16 in

B - Width of Clevis Support Section

 N/A 17/32 in

C - Length of Pin Reduced Section, Instrumented Zone

 N/A 3/8 in

Dp - Nominal Pin Diameter

 N/A 1.187 in

E - Active Length of Pin

 N/A 2-5/8 in

F - Clevis Pin Head Length

 N/A 2 in

G - Extension of Pin for Keeper Plate Installation

 N/A 5/8 in

H - Width of Keeper Plate Slot

 N/A 17/64 in

J - Depth of Keeper Plate Slot

 N/A 1/4 in

L - Overall Length of Pin

 N/A 5-1/4 in

U - Nominal Spacer Thickness

 N/A 1/8 in

Weight

 N/A 2.1 lb

Safety Factor

 N/A 4.1

Keeper Plates

 N/A SPA-16-112-1-A

Connector Type

 N/A Axial Connector Permanently Attached Axial Cable

Performance Specs

Overload without Zero Shift

 N/A 150%

Overload without Failure

 N/A 300% (Minimum)

Bridge

 N/A Full bridge 350 Ohm (Nominal)

Excitation

 N/A 12 V AC (Maximum) 12 V DC (Maximum)
Output Signal1 N/A 2-mV/V (Nominal) 2-mV/V (Standardized Output)

Non-Repeatability

 N/A ±0.15% FS (Nominal)

Non-Linearity

 N/A ±0.50% FS (Nominal)

Hysteresis

 N/A ±0.50% FS (Nominal)

Service Temp Range

 N/A to 150 °F

Temp Effects (on Zero)

 N/A 0.005% FS / °F (Nominal)

Temp Effects (on Output)

 N/A 0.008% load / °F (Nominal)
Zero Balance2 N/A ±2% FS (Nominal)

Electrical Specifications

Receptacle

 N/A PTIH-10-6P

Mating Plug

 N/A PT06A-10-6S (SR)

     Function

 N/A Pin

     (+) Excitation

 N/A A

     (-) Excitation

 N/A D

     (+) Signal

 N/A B

     (-) Signal

 N/A C

Cable

 N/A #20(26x34) AWG., rubber insulation, shielded, rubber jacket, 4-Conductor (Standard Cable)

     Function 

 N/A Wire Code

     (+) Excitation 

 N/A Red

     (-) Excitation 

 N/A Black

     (+) Signal 

 N/A Green

     (-) Signal 

 N/A White
  • 1 Exact output provided with calibration data. (Standardized outputs are optional). In addition, Strainsert factory calibrations are intended to simulate installed conditions, however, it is recommended that an in-place calibration be performed to account for any installation, tolerance, and/or alignment influences affecting sensor measurement.
  • 2 Prior to loading, it is necessary to initially/periodically null the zero load output to account for any residual offset.